How can I take this chair apart?
Okay sorry, this is hard to explain so I’ll do my best…
I removed the seat of the chair no problem but I cannot figure out how to get the back off. There are no visible screws on the back to hold it to the frame.
http://s576.photobucket.com/albums/ss209/ladygish/?action=view¤t=1-1.jpg
The backs were clearly assembled into one piece *before* being put on the chair frame because the decorative brads (which I’ve removed) continue under the bars of the frame. Each bar has 2 "connection points" that I can’t tell what they are. There appears to be a washer along with what I assume is a screw.
http://s576.photobucket.com/albums/ss209/ladygish/?action=view¤t=2.jpg
I removed the brads just to check, but I still can’t get to whatever is holding the backs on. The brads only hold a piece of cardboard covered in vinyl to the back.
This is a kind of small picture, but this looks almost identical to my frame. (Don’t know if it’s helpful.)
http://www.barstoolsandchairs.com/50sdinerchair-frame.aspx
So how do I take this thing apart? The vinyl is cracked very badly and needs to be replaced. Also, What is the name for the little feet on the chair legs and how do I remove these:
http://s576.photobucket.com/albums/ss209/ladygish/?action=view¤t=3.jpg
Two of the chairs have plastic caps on the feet and two have these things. I’d like them to all match. Thanks so much and 10 points for the best answer!!
And your answer, Adolph, is why idiots shouldn’t attempt to answer questions. Since you clearly don’t know the answer either, don’t waste my time.
It’s not really a problem if I have to cut through the vinyl/padding to get to the rivet since the padding needs to be replaced on a couple of the chairs anyway. If I do this, how can I remove the rivet? It feels like this must be doable because the website I linked to before sells this sort of frame to be used with the original seats and backs.
I wouldn’t think the feet are welded on just because half of the chairs don’t have them. Any other ideas anybody?